Confronting COVID-19 with Optics & Photonics

Confronting COVID-19 with Optics and Photonics

At the zenith of such a situation when the whole world is fighting against a pandemic COVID-19, a multidirectional approach for combating requires excessive attention. The quick detection of infected patients stands as a primary challenge due to variability in the symptoms. Though the field of Optics and Photonics provides various conventional molecular analysis instruments such as multiple spectrum cameras, multispectral optical spectrometers, and they still couldn’t achieve a potential detection method for the masses. Moreover, these methods are time-consuming, prone to error, and may lead to respiratory infections.

Recently, a method involving biosensor which uses thermal and optical effect for safe and reliable detection of COVID is to be seen in a picture. The Plasmonic biosensor used for detection combines Plasmonic Photothermal (PPT) and Localized Surface Plasmon Resonance (LSPR) on a tiny gold nanoisland chip kept on a glass substrate. Artificially produced DNA receptors that match specific RNA sequences of the SARS-CoV-2 virus are grafted onto the AuNI chips. Through Nucleic Acid Hybridization, sensitive detection of specific RNA sequences of the SARS virus is done. LSPR creates plasmonic near field by exciting the metallic nanostructure. The change in the refractive index is measured using an optical sensor helping in determining if the sample contains RNA strands of SARS. The LSPR response due to plasmonic sensing determines the concentration of sequences ranging from 1 pM to 1 nM. PPT helps in boosting the ambient temperature to secure the detection of only reliable matching of RNA strand and DNA receptor.

The sensing stability, sensitivity, and reliability of the device can be significantly enhanced by measuring the same at 2 different angles under 2 different wavelengths. The thermo-plasmonic heat is generated on the AuNI chips while being illuminated at their plasmonic resonance frequency for better sensing performance. The localized PPT heat can elevate the hybridization temperature during the process and facilitate the accurate discrimination of two similar gene sequences.
Though this technique is not yet efficient for a high frequented location, yet it embarks a step closer towards the modern techniques of simulations for such complicated processes.

ANSYS Lumerical Suite comes with all the tools which are required to simulate surface plasmon resonance(SPR) and photothermal heating in plasmonic nanostructures. It comes with a Finite difference time domain (FDTD) solver and heat transport solver for thermal simulation.

The picture below (fig 1) shows the simulation done for getting a source incidence angle that excites the SPR. The absorption in the Silver was measured to determine the angle with the strongest coupling.

Fig:1 Electric Field intensity vs Incident Angle
Source: Lumerical Knowledge Base
Simulation is done on plasmonic nano-structures to understand the effect of varying optical intensity on the performance
Source: Lumerical Knowledge Base

Want to explore how ANSYS solutions can help you in speeding your photonics research? Visit us at

Share this on:

Leave a Reply

Your email address will not be published. Required fields are marked *